How To Attach A Ledger Board Stucco House For Patio Covers In

How To Attach A Ledger Board Stucco House For Patio Covers

A ledger board is a horizontal board that is attached to the exterior wall of a house and supports the weight of a patio cover. Ledger boards are typically made of pressure-treated lumber and are installed using lag bolts or screws. When attaching a ledger board to a stucco house, it is important to take steps to prevent water from entering the wall behind the ledger board. This can be done by using flashing and sealant around the perimeter of the ledger board.

Materials

To attach a ledger board to a stucco house, you will need the following materials:

Pressure-treated lumber (2x8 or 2x10)
Lag bolts or screws
Flashing
Sealant
Drill
Level
Hammer
Caulk gun

Instructions

To attach a ledger board to a stucco house, follow these instructions:

Locate the desired location for the ledger board. The ledger board should be installed at a height that is level with the top of the patio cover posts.
Mark the location of the ledger board on the stucco wall. Use a level to ensure that the ledger board will be installed level.
Cut the ledger board to the desired length. The ledger board should be long enough to span the width of the patio cover.
Apply flashing to the top of the stucco wall. The flashing should be wide enough to extend at least 6 inches beyond the edge of the ledger board. Secure the flashing to the wall using roofing nails or screws.
Place the ledger board on top of the flashing. Align the ledger board with the marks that you made on the wall. Use a level to ensure that the ledger board is level.
Drill pilot holes through the ledger board and into the stucco wall. The pilot holes should be spaced 16 inches apart.
Insert lag bolts or screws into the pilot holes. Tighten the lag bolts or screws until the ledger board is securely attached to the wall.
Apply sealant around the perimeter of the ledger board. The sealant will help to prevent water from entering the wall behind the ledger board.

Tips

Here are a few tips for attaching a ledger board to a stucco house:

Use pressure-treated lumber for the ledger board. Pressure-treated lumber is resistant to rot and decay.
Use lag bolts or screws that are long enough to penetrate the stucco wall and into the framing behind the wall.
Apply flashing to the top of the stucco wall to prevent water from entering the wall behind the ledger board.
Seal the perimeter of the ledger board with sealant to prevent water from entering the wall behind the ledger board.